This table has been pre-assembled at the factory.
|
1.
|
Unpack all items |
|
2.
|
Lay top face down on a padded
surface |
|
3.
|
 Place
dowel pins in leg assemblies |
|
4.
|
Match leg and aprons by letter
designation |
|
5.
|
 The
sides of the aprons with the slots go toward the tabletop.
Push aprons ends onto the dowels in the leg assemblies.
Do not push pins all the way in. |
|
6.
|
 Before
completely pushing the pins into the aprons, place corner
bracket ‘C’ into slot on the leg assembly and
over the bolt in the leg and into the slot on the apron.
Now push the apron all the way in. Place a washer and
nut on each corner bolt and hand tighten. Do not fully
tighten at this time. Place the assembled base on the
bottom side of the top making sure that all numbers on
the top match the numbers on the aprons. Align leg corners
with the outline of the leg corners on the tabletop. |
|
7.
|
 Place
a tabletop hold down bracket into each of the slots on
the table base, the side of the bracket with a hole goes
toward the top. Insert screws into the holes of the brackets
on one side of the table. Now check to be sure all leg
corners line up with the outline on the tabletop. When
alignment (it may be necessary to slightly loosen nuts
on corner brackets in order to get proper alignment) is
complete insert screws into remaining brackets and tighten
fully. |
|
8.
|
 Now
tighten nuts on corner bracket with a wrench applying
a firm amount of pressure making sure the flanges on the
brackets remain in the slots on the aprons and that there
is no gap between the legs and the aprons. |
|
9.
|
 Place
two screws diagonally from each other in the screw holes
in the corner brackets tighten fully. |
|
10.
|
Invert table and finish as
desired. |
