This table has been pre-assembled at the factory.
Bases
Table Tops
Hardware
Tile Spacers
|
1.
|
If multiple tables were ordered.
Unpack all tables. |
|
2.
|
Sort and match tabletops and
bases. |
|
3.
|
Each top and each base has
a number and these numbers must be matched before assembly. |
|
4.
|
Place the top upside down
on a padded flat surface. |
|
5.
|
Take the correspondingly numbered
base and place it on the tabletop. |
|
6.
|
 Align
the letters of the top hold-downs with the corresponding
slots in the table base. Only one slot and one hold-down
are numbered on each table. |
|
7.
|
To assure equal overhangs
on all sides, line up legs with outline marks on each
underside corner of the top. |
|
8.
|
 Insert
the hold down clips in each hold down slot. |
|
9.
|
 Tighten
each screw on the hold down clips until resistance is
felt. Make sure the alignment of the base to top corner
markings is correct. |
|
10.
|
After all screws are tight
go back and give each screw another quarter of a turn
to snug top to base. |
